Branded Oil in UAE

 The Branded Oil in UAE task of making sure that components received are correct is a joint responsibility of the supplier and the customer. Limits must be set and agreed to by both parties and adhered to without lapses.

Additives are a more complex system, but even the most basic of components has the same rules. Another aspect of ensuring quality is quality protection. 

Again, I was involved in an incident that was the result of poor quality protection practice. We were getting 100 neutral Industrial oils UAE from a supplier. With viscosity of 20 costs at 40 C, 100N base stock is used in lower-viscosity motor oil and transmission fluids. The supplier was an old source to us, so we were pretty confident of their product quality. However, we began receiving railcars with cloudy oil. The obvious source was water. We checked with the supplier, and they assured us that nothing had changed. 

This continued off and on for a few shipments. We requested that we be allowed to review the operation ourselves. One of our purchasing people and a technical service representative visited the plant. The biggest grease exporter in UAE, which had capacity to carry 23,000 gallons, was rolled up to the loading spot and the central dome was opened up. A fill spout from the main bulk storage of 100N was swung over the car and began to load through the dome. 

If you have any worry about your car or any vehicle, feel free to contact us at technolube. Were it not for bad weather, it might have taken a lot longer to figure out the problem, but it started to rain. There was no roof over the fill spot and no tarp or other protective covering placed over the dome, so some rainwater mixed in with the load. It only takes about 20 parts per millions of water to cause a haze in grease, which in this case was less than 0.5 gallons. The point of the story is that your suppliers need to protect the quality of their products or there will be problems.

Quality assurance is a way of preventing mistakes and defects in manufactured products and avoiding problems when delivering products or automotive engine oils services to customers. Not only are your suppliers obligated to send you on-spec components, but you are expected to send on-spec products and services to your customers. This one is where the rubber meets the road, and of course I have an example of this as well. 

As some of you may know, outboard motor oil has some unique characteristics. Since it is designed to lubricate a water-cooled two-cycle engine, the oil is mixed with fuel at a relatively high ratio of fuel to oil (100:1). These formulations are also usually ashes.

Comments

Post a Comment

Popular posts from this blog

Biggest Lubricant Oils Manufacturer in UAE

 Oil protects critical engine components from damage and found that lubricant engine oils performed an average of 47 percent better than conventional oils in a variety of industry-standard tests. With its superior resistance to deterioration, findings indicate that Technolube is particularly beneficial to newer vehicles with turbo-charged engines and for vehicles that frequently drive in stop-and-go traffic, tow heavy loads or operate in extreme hot or cold conditions. We’ve established that Biggest Lubricant Oils Manufacturer in UAE outperforms lubricant oil. So, what benefits might drivers expect after switching to Technolubeuae. Drivers have told us that wear protection is the number-one benefit they demand from car engine oil. If car engine oil could make your car fly, but couldn’t keep components from wearing out and failing, what good would it is. Technolube automotive lubricant oils in UAE do a better job protecting against engine wear. It forms a stronger fluid film t...
Read more

Biggest Lubricant Oils Manufacturer in UAE

 As a leading supplier for the automotive aftermarket, the combined company will have tremendous opportunities for growth, both through organic initiatives and accretive acquisitions. The largest private Biggest Lubricant Oils Manufacturer in UAE and automotive chemical distributor located in UAE. It has capacity to make more than 140 million gallons of lube per year at blending plants in Abu Dhabi, Dubai, Sharjah, Umm al-Qaiwain, Fujairah, Ajman and Ra's al-Khaimah. Highline also owns Service Champ, which offers engine oils and a range of other products such as oil filters, windshield wipers, air filters and cleaning products to quick-lubes and other automotive lubricants UAE installers across the country. Highline is based in Memphis and is majority owned by the Sterling Group. Its CEO, will lead the combined business. Highline offers a wide range of com mercial lubrican ts and other automotive aftermarket products to oil jobbers, distributors, retailers...
Read more

Automotive Engine Oil in UAE

Under some conditions, like shock loads, critically low viscosity, very high temperatures, and/or constant heavy loading, a lubricant may not stay in its usual hydrodynamic film condition. A condition starts when there is boundary lubrication, a form of contact between engine wear surfaces, and then damage starts occurring. If the above-mentioned conditions are not solved immediately and the contact continues, then there could be a failure within hours because of a lack of lubricant film. Engine oil companies in UAE and elsewhere should consider viscosity, shear stress or shear rate and viscosity index when they blend lubricating oils. For the end customer, it all means that engine oil’s viscosity is the most significant consideration when choosing the product for a particular application. The capability of engine oil to withstand shearing is another factor to consider when measuring viscosity. For the uninitiated, shearing is the process of a lubricant plane tearing away from a ...
Read more